Search Results for

    Show / Hide Table of Contents

    Audio Editor


    Audio Editor Interface

    Audio Editor allows for editing audio assets. Double-clicking on an audio asset displayed in Assets Details will open this editor. The editor is composed of two main parts:

    Viewport

    The viewport shows the waveform of the audio asset. At the top of the viewport, the original audio file properties are displayed, while above the toolbox, the audio asset properties are shown. These parameters depend on the properties panel. The viewport has a toolbox at the bottom that allows you to test the audio.

    Icon Description
    Play Plays the audio asset.
    Loop Enable/Disable playing in a loop.
    Volume Adjust the volume of the playing audio.
    Panning Control the distribution of the audio signal to listen more through the right or left speaker.
    Speed Decrease/Increase the audio speed.

    Properties

    The audio properties that you can configure are:

    Property Available values Description
    ChannelFormat Mono / Stereo The number of channels of audio wave data.
    SampleRateMode Low / High The sample rate of audio wave data. A high sample rate improves the quality but increases the file size.
    Encoding PCM8 / PCM16 Pulse Code Modulation bits.
    In this article
    Back to top
    Generated by DocFX